Sawaal

 CCNA Questions

Popular Latest Rated
Q:

You want to run the new 802.1w on your switches. which of the following would enable this protocol?

A) Switch (config) # Spanning-tree mode rapid-pvst B) Switch#spanning-tree mode rapid-pvst
C) Switch (config)#spanning-tree mode 802.1w D) Switch#spanning-tree mode 802.1w
 
Answer & Explanation Answer: A) Switch (config) # Spanning-tree mode rapid-pvst

Explanation:

802.1w is the also called Rapid Spanning Tree Protocol. It is not enabled by default on Cisco switches, but it is a better STP to run since it has all the fixes that the Cisco extensions provide with 802.1d

Report Error

View Answer Report Error Discuss

Filed Under: CCNA

0 8711
Q:

Which layer is responsible for converting data packets from the Data Link layer into electrical signals?

Answer

The physical layer takes frames from the Data Link layer and encodes the 1s and 0s into a digital signal for transmission on the network medium.

Report Error

View answer Workspace Report Error Discuss

Subject: CCNA

7 8464
Q:

Which layer combines bits into bytes and bytes into frames, uses MAC addressing , and provides error detection?

Answer

The Data Link layer is responsible for the framing of data packets.

Report Error

View answer Workspace Report Error Discuss

Subject: CCNA

10 8321
Q:

What is the purpose of Spanning Tree Protocol in a switched LAN?

A) To provide a mechanism for network monitoring is switched environments B) To prevent routing loops in network with redundant paths
C) To prevent switching loops in networks with redundant switched paths D) To manage the VLAN database across multiple switches
 
Answer & Explanation Answer: C) To prevent switching loops in networks with redundant switched paths

Explanation:

The Spanning Tree Protocol (STP) was designed to stop layer 2 loops. All Cisco switches have the STP on by default.

Report Error

View Answer Report Error Discuss

Filed Under: CCNA

1 8093
Q:

What protocol would you use if you were running xDSL and needed authentication?

Answer

PPPoE  or  PPPoA

Report Error

View answer Workspace Report Error Discuss

Subject: CCNA

24 8060
Q:

Which layer of the OSI model offers three different modes of communication : Simplex, half duplex, and full duplex?

A) Presentation B) Transport
C) Application D) Session
 
Answer & Explanation Answer: D) Session

Explanation:

The Session layer of the OSI model offers three different modes of communication : Simplex, half duplex, and full duplex.

Report Error

View Answer Report Error Discuss

Filed Under: CCNA

1 7900
Q:

You want to ping the loopback address of your IPv6 local host. What will you type?

A) Ping 127.0.0.1 B) Ping 0.0.0.0
C) Ping ::1 D) trace 0.0. :: 1
 
Answer & Explanation Answer: C) Ping ::1

Explanation:

The loop back address with IPv4 is 127.0.0.1 . With IPv6, that address is ::1

Report Error

View Answer Report Error Discuss

Filed Under: CCNA

1 7894
Q:

Which of the following descriptions about IPv6 is correct?

A) Addresses are not hierarchical and are assigned at random B) Broadcasts have been eliminated and replaced with multicasts
C) There are 2.7 billion addresses D) An interface can only be configured with one IPv6 address
 
Answer & Explanation Answer: B) Broadcasts have been eliminated and replaced with multicasts

Explanation:

There are no broadcasts with IPv6. Unicast , multicast, anycast, global, and link - local unicast are used.

Report Error

View Answer Report Error Discuss

Filed Under: CCNA

1 7612