Questions

776 BC

I. Inputs

• Quality management plan


• Quality metrics


• Process improvement plan 


• Work performance information 


• Approved change requests


• Quality control measurements 


• Implemented change requests


• Implemented corrective actions 


• Implemented defect repair


• Implemented preventive actions 

II. Tools and Techniques

• Quality planning tools and techniques


• Quality audits


• Process analysis 


• Quality control tools and techniques

III. Outputs

• Requested changes


• Recommended corrective actions


• Organizational process assets (updates)


• Project management plan (updates)

About 71% of the earth's surface is covered with water. In that 71% only 4% of water is a fresh water.

Cross Contamination ::

Cross Contamination is nothing but a contamination in a cross way i.e, when a bacteria on a kitchen tool transfers to food via direct contact. Two of the most common kitchen tools usually tend to be a knife or a cutting board. However, it is not just bacteria that gets carried from one place to another — it could also be a virus also.

Cross Contamination is prevented by the following tips ::

1. Use separate equipment

2. Clean and sanitize all work surfaces

3. Remind employees to wash their hands

4. Purchase prepared food

5. Implement a personal hygiene program.

I. Inputs

• Work performance information


• Performance measurements


• Forecasted completion


• Quality control measurements


• Project management plan

                - Performance measurement baseline

• Approved change requests


• Deliverables

II. Tools and Techniques

• Information presentation tools


• Performance information gathering and compilation


• Status review meetings


• Time reporting systems


• Cost reporting systems

III. Outputs

• Performance reports


• Forecasts


• Requested changes


• Recommended corrective actions


• Organizational process assets (updates)

This section identifies and describes the five Project Management Process Groups required for any project. These five process Groups have clear dependencies and are performed in the same sequence on each project.

The five Process Groups are :

Initiating  Process Group - Defines and authorizes the project or a project phase

Planning Process Group - Defines and refines objectives, and plans the course of action required to attain the objectives and scope that the project was undertaken to address.

Executing Process Group - Integrates people and other resources to carry out the project management plan for the project

Monitoring and Controlling process Group - Regularly measures and monitors progress to identify variances from the project management plan so that corrective action can be taken when necessary to meet project objectives.

Closing Process Group - Formalizes acceptance of the product, service or result and brings the project or a project phase to an orderly end.