Questions

The number of blueberries is equal to number of cups multiplied by 4 minus one left.

That is :

      B = 9(C - 2) -> (1)

Then the number of blueberries will be equal to the number of cups times three plus one left.

That is :

      B = 6C + 3 -> (2)

Now substitute the 1st and 2nd equations:

      B = 9(C - 2)

      B = 6C + 3

      C = 7, B = 45.

Therefore Blueberries = 45 and cups = 7.

A Festival of India is being organized in the Netherlands from 26 January – 27 March 2017. The events will be held in the cities of The Hague, Amsterdam, Rotterdam/Maastricht, Utrecht, Eindhoven and Groningen.

Jenita's color should be yellow. John's color cannot be violet and red, it might be yellow or green. As Jenita's color is yellow, so John's color will be green. Maria's do not like violet, so her color must be Red. Then Julie's color is violet.

Lead caulked joints are used for laying Earthern ware pipes.

Earthenware is fired at 1900 degrees Fahrenheit, much lower than stoneware. The result is porous pottery that is not as strong as stoneware or porcelain pottery pieces and is cheaper than stoneware.

Suppose your flip-flop is positive edgetriggered. time for which data should be stable prior to positive edge clock is called setup is called setup time constraint.

Time for which data should be stable after the positive edge of clock is called as hold time constraint.

If any of these constraints are violate d then flip-flop will enter in meta stable state, in which we cannot determine the output of flip-flop.

there are two equation:

1. Tcq + Tcomb > Tskew + Thold

2. Tcq + Tcomb > Tskew + T - Tsetup

Tcq is time delay when data enters the flip flop and data comes at output of flip flop.

Tcomb is the logic delay between two flip flop.

Tskew is the delay of clock to flip flop: suppose there are two flip flop, if clock reaches first to source flip flop and then after some delay to destination flip flop, it is positive skew and if vice versa then negative  skew. 

so if you take 2 eq you will see that setup time is the determining factor of clock's time period.